WAGO 750-514 2-channel relay output; 125 VAC; 0.5 A; Potential-free; 2 changeover contacts, I/O System 750/753.

This digital output module transmits control signals from the automation device to the connected actuators.

The internal system voltage triggers the relay.

The NO contacts are electrically isolated.

The state of the relay is indicated by a LED.

Technical data

Number of digital outputs 2

Total number of channels (module) 2

Signal type Digital

Actuator connection 2 x (1-wire)

Output circuit design 2 changeover contacts

Relay

Output characteristic potential-free

Pull-in time (max.) 4ms

Drop-out time (max.) 4ms

Switching frequency (max.) 0.33 Hz

Switching voltage (max.) 125 VAC, 30 VDC

Switching current (max.) 0.5A

Switching current (note) 0.5 A at 125 VAC; 1 A at 30 VDC

Switching voltage (min.) 0.01V

Switching current (min.) 0.01mA

Switching power 62.5 VA / 30 W

Electrical switching operations (min.) (at max. resistive load) 100 x 10³ switching operations

Mechanical switching operations (min.) (at max. resistive load) 100 x 10⁶ switching operations

Output data width (internal) max. 2Bit

Supply voltage (system) 5 VDC; via data contacts

Current consumption (5 V system supply) 70mA

Supply voltage (field) Transmission of ground potential via power jumper contact

Isolation 1500 V (system/field)

Indicators LED (A, C) green: Status relay 1, relay 2

Number of incoming power jumper contacts 1

Number of outgoing power jumper contacts 1

Current carrying capacity (power jumper contacts) 10A